How To Create A Rim Light On A Budget

A quick budget way to light a wine glass with the edges highlighted.

Posted 07/Feb/2012 - 1:22PM

Words and pictures, Peter Bargh ePHOTOzine.

Before we move on to the 'how to' please note that I've done this in the crudest and fastest possible way to show that you can produce studio quality results with the minimum of gear and time. While it helps to have studio flashes, softboxes, reflectors, stands, luxury backdrops and a still-life table, you don't need them. The effect can be created with minimal kit (good news when you're trying to save money or are just starting out in produce photography). As you'll see here:

Light Source
To get the rim light effect you need to light the glass from behind. You can use flash guns or, in this case, two reading lamps turned on their sides. Any light source will do but the important thing is not to have any spillage or you end up with more reflections than you want on the glass.

What else do you need?
You need a black background. I used some old velvet material that I bought for a few quid many years ago. It used to be my window blackout blind in the darkroom and now makes a useful backdrop.

Set-up
I placed a chair behind and draped the material over it and onto the table to create a curve. No need for an expensive still life bench! Next I placed the lamps at each side, laid on their side so the bulbs are at glass level and near to the background, leaving a wide enough space in the middle for the wine glass.

The glass is placed forward of the lamps. Now I needed a screen for the blub so stray light didn't spill onto the glass and a sheet of white paper to diffuse the lamp and spread the white reflection over the glass. I used two ring binders opened so they free stand and taped one edge of the white paper to this. I used normal lined A4 paper to show you don't even have to go expensive on the paper you use. The paper sheets were then adjusted so they curved slightly around the lamps. If you want to make a better job you would use larger sheets along with black card to diffuse, spread or mask light.

Set the camera up parallel to the glass, look through the viewfinder and adjust the position of the glass (front to back) and the folders/white paper until the white rim highlight is the thickness you desire on the edges of the glass. Don't worry at this stage about spillage on the background as that can be cleaned up later in Photoshop. Take your shot. Auto metering will probably give the result you're after, but you can check it on the LCD and re-shoot if necessary.

Finished image
Below is the result of my simple set up. Left is a shot straight out of the camera and the right is a shot with colour correction and some burning in of light spillage on the background which was completed in Photoshop.

 

 

Comments

No one has commented on this yet. Be the first!

Leave a Comment

You must be a FPME member to comment. Join FPME Today!